Take control of adhesive placement with programmable hot melt pattern controllers and line-speed-based control solutions.
Explore single-, dual-, and four-channel pattern controllers, plus line-speed-responsive adhesive pressure control.
Program glue timing sequences with adjustable delay, glue, and skip stages. Select from nine programs and fine-tune application behavior using simple front-panel controls.
View Specifications →Convert line-speed information into a configurable 0–10 V control output for compatible adhesive pressure-control equipment, helping maintain application consistency as production speed changes.
View Specifications →Two independent sensor inputs and two glue-gun outputs in one controller. Nine stored programs, stitch mode, purge/test firing and 1 ms timing resolution.
View Specifications →Four sensor inputs and four adhesive outputs, with time-based or distance-based programming, six events per program, nine stored programs, stitch mode and low-speed cutoff in distance mode.
View Specifications →| Specification | TPC-9 | TPC-92 | Bead Master 4469 |
|---|---|---|---|
| Channels | 1 | 2 | 4 |
| Stored programs | 9 | 9 | 9 |
| Events per program | 4 | 4 | 6 |
| Sensor inputs | 1 | 2 | 4 |
| Glue outputs | 1 | 2 | 4 |
| Output voltage | 24 VDC | 24 VDC | 24 VDC |
| Output fuse | 2.5 A | 2.5 A | 2.5 A |
| Input power | 120/240 VAC, 50/60 Hz | 120/240 VAC, 50/60 Hz | 120/240 VAC, 50/60 Hz |
| Programming | Time-based | Time-based | Time or distance |
| Stitch mode | Yes | Yes | Yes |
Specifications summarized from the existing controller portfolio; confirm electrical configuration and application compatibility before ordering.
Set glue timing and sequence to match your packaging application.
Store and select repeatable patterns for changing production requirements.
Coordinate compatible pressure-control equipment with changing line speeds.
Accessible front-panel programming and adjustments.
Target adhesive where the application needs it rather than over-applying.
Designed around the demands of automated packaging and gluing lines.
A typical pattern-control system coordinates detection, timing, and adhesive application. Exact wiring and compatibility depend on your equipment.
A sensor detects the product moving through the line.
The controller follows the selected timing sequence.
Control signals actuate compatible adhesive applicators.
Adhesive is deposited according to the programmed pattern.
This website is a product and technical information resource for end users and independent distributors. For product selection, availability, pricing, purchasing, installation, and support, please work directly with your existing equipment distributor.
Browse controller capabilities, compare specifications, and share product information with your team. This website does not accept direct orders or sales inquiries.